Bend Aid
Three different types are available.
How to make bends :
Loosening the main screw lifts the upper part of the tool a little, so that the PE can be placed between the baseplate and an apropriate holding finger . Fix the part by turning the main screw .
A gap , milled into the baseplate right to the edge of the upper plate allows to place a razor blade between the PE part and the base. Bending is performed by mooving the razor blade up to the desired angle of bending . Depending on your PE parts a little overbending may be necessary. Therefore all edges are milled at an 75° angle .
For multiple bent parts : turn around your bent part and make the next bend using one of the different fingers .
 |
BEND AID 150 : about 155 in lenght
with 8 fingers from 2 to 25 mm . Two 40mm edges and a 155 mm long one .
Two fixing screws to generate even pressure along the whole length .
For all scales and uses. | |
|
Price:
54.00 Euro EC |
|
|
BEND AID 100 : is 100 mm in lenght with 5 fingers
from 2 to 25 mm , two 40mm side edges and the back one with 100 mm ..
Standard for scales up to 1/35
Price: 43.00 Euro EC | 35.83 Export |
|
|
BEND AID 40 : 40 mm * 40 mm bending plate on a 50 * 50 mm baseplate . 5 Fingers from 2 - 7 mm , a 40 mm edge and Main use on small scale parts and ships etchings .
Price: 33.00 Euro EC
| 27.50 Export If you buy it together with either a Bend Aid 100 or 150 : 29.00 Euro EC 24.17 Export |
|
| |